
Extractor Tool for Mini-Fit ? Series Terminals
Terminal Series No.
Terminal Order No.
44485 44485-5211
44485-5212
44485-5311 44485-5312
44485-5411
44485-5412
45750
46012
45750-1111
45750-3211
46012-1141
46012-3241
45750-1112
45750-3212
46012-1142
46012-3242
45750-1211 45750-1212
45750-4111 45750-4112
46012-1241 46012-1242
45750-3111
45750-4211
46012-3141
45750-3112
45750-4212
46012-3142
46018 46018-1541
46083-1111
46018-1542
46083-1112
46018-2541
46083-1121
46018-2542
46083-1122
46018-3541
46083-1211
46018-3542
46083-1212
46083
46083-1221
46083-2211
46083-1222
46083-2212
46083-2111
46083-2221
46083-2112
46083-2222
46083-2121
46083-3111
46083-2122
46083-3112
46083-3121
46098 46098-1541
46083-3122
46098-1542
46083-3211
46098-2541
46083-3212
46098-2542
46083-3221
46098-3541
46083-3222
46098-3542
5378 39-00-0029
39-00-0030
OPERATION:
1. Insert the extractor tool into the housing as shown in Figure 1.
2. Use the slots located on the inside of the housing to guide the extraction tool blades into the housing until
contact is made with terminal.
3. Continue to insert the tool always checking to see that the blades of extraction tool are on the outside of the
contact as shown in Figure 2.
4. Continue to insert extraction tool into housing until the locking tangs have snapped out of their locked
position. If the terminal locking tabs are still not totally depressed, hold on tight to the wire and push it
towards the extractor tool, this will completely depress the locking tabs. See Figure 2.
5. Gently pull the terminal by the wire, out from the housing.
PULL WIRE AND
TERMINAL
TERMINAL
HOUSING
SLOTS FOR
EXTRACTOR
TOOL
EXTRACTOR
TOOL
Figure 1
Doc No: ATS-011030044
Revision: H
Release Date: 03-01-05
Revision Date: 08-05-09
UNCONTROLLED COPY
Page 2 of 3